STIHL MS 880 R MAGNUM Manuel d'instructions télécharger pdf (Page 45)

MS 880

English

43

For periods of 3 months or longer

N Drain and clean the fuel tank in a

well ventilated area.

N Dispose of fuel properly in

accordance with local

environmental requirements.

N Run the engine until the carburetor

is dry – this helps prevent the

carburetor diaphragms sticking

together.

N Remove the saw chain and guide

bar, clean them and spray with

corrosion inhibiting oil.

N Thoroughly clean the machine –

pay special attention to the cylinder

fins and air filter.

N If you use a biological chain and bar

lubricant, e.g. STIHL BioPlus,

completely fill the chain oil tank.

N Store the machine in a dry, high or

locked location, out of the reach of

children and other unauthorized

persons.

N Remove chain sprocket cover, saw

chain and guide bar.

N Release chain brake – pull hand

guard against the front handle

Fit new chain sprocket

– after use of two saw chains or

earlier

– if the wear marks (arrows) are

deeper than 0.02 in (0.5 mm) –

otherwise the service life of the saw

chain is reduced – use check gauge

(special accessory) to test

Using two saw chains in alternation

helps preserve the chain sprocket.

Use only STIHL original chain sprockets

to ensure reliable functioning of the

chain brake.

N Use a screwdriver to remove the E-

clip (1)

N Remove the washer (2)

N Remove rim sprocket (3)

N Inspect transport profile on the

clutch drum (4) – if there are also

heavy signs of wear, also replace

the clutch drum

N Remove clutch drum or spur chain

sprocket (5) including needle

cage (6) from the crankshaft – with

versions with two chain brake

systems, press throttle lock

beforehand

Storing the Machine Checking and Replacing

the Chain Sprocket

001BA121 KN

001BA122 KN

1

2

4

5

6

1

2

3

6

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 123 124

Commentaires sur ces manuels

Pas de commentaire