STIHL MS 880 R MAGNUM Manuel d'instructions Page 8
- Page / 124
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
MS 880
English
6
Screw cap
See "Fueling" chapter in your instruction
manual.
Before Starting
Take off the chain guard (scabbard) and
inspect the saw for proper condition and
operation. (See the maintenance chart
near the end of the instruction manual.)
For proper assembly of the bar and
chain follow the procedure described in
the chapter "Mounting the Bar and
Chain" of your instruction manual.
STIHL Oilomatic chain, guide bar and
sprocket must match each other in
gauge and pitch. Before replacing any
bar and chain, see the chapter entitled
"Specifications" in the instruction
manual and the section "Kickback" and
the "ANSI B 175.1-2000 chain saw
chain saw kickback standard" below.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, fuel mix,
grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
Starting
Start and operate your saw without
assistance. For specific starting
instructions, see the appropriate section
of the instruction manual. Proper starting
methods reduce the risk of injury.
Fold the grip flush with
the top of the cap. If the
grip does not lie com-
pletely flush with the cap
and the detent on the grip
does not fit in the corre-
sponding recess in the
filler opening, the cap is
not properly seated and
tightened and you must
repeat the above steps.
Warning!
Unit vibrations can cause an improperly
tightened fuel filler cap to loosen or
come off and spill quantities of fuel. In
order to reduce the risk of fuel spillage
and fire, tighten the fuel filler cap by
hand as securely as possible.
The screwdriver end of
the STIHL combination
wrench or other similar
tool can be used as an
aid in tightening slotted
fuel filler caps.
Warning!
Always check your power tool for proper
condition and operation before starting,
particularly the throttle trigger, throttle
trigger interlock, stop switch and cutting
tool. The throttle trigger must move
freely and always spring back to the idle
position. Never attempt to modify the
controls or safety devices.
Warning!
Never operate your power tool if it is
damaged, improperly adjusted or main-
tained, or not completely or securely
assembled.
Warning!
Check that the spark plug boot is
securely mounted on the spark plug – a
loose boot may cause arcing that could
ignite combustible fumes and cause a
fire.
Warning!
Proper tension of the chain is extremely
important. In order to avoid improper
setting, the tensioning procedure must
be followed as described in your man-
ual. Always make sure the hexagonal
nut(s) for the sprocket cover is (are)
tightened securely after tensioning the
chain in order to secure the bar. Never
start the saw with the sprocket cover
loose. Check chain tension once more
after having tightened the nut(s) and
thereafter at regular intervals (whenever
the saw is shut off). If the chain
becomes loose while cutting, shut off
the engine and then tighten. Never try to
adjust the chain while the engine is
running!
Warning!
To reduce the risk of fire and burn inju-
ries, start the engine at least 10 feet
(3 meters) from the fueling spot, out-
doors only.
- STIHL MS 880 1
- Instruction Manual 2
- Manual de 2
- 59 - 119 2
- Contents 3
- Guide to Using this Manual 4
- Safety Precautions and 4
- Working Techniques 4
- 001BA087 LÄ 10
- 001BA082 KN 11
- 001BA093 LÄ 13
- 001BA174 KN 15
- 001BA037 KN 17
- 001BA038 KN 17
- 001BA088 LÄ 18
- 001BA146 KN 19
- 001BA153 KN 19
- 001BA143 KN 19
- 001BA150 KN 20
- 001BA144 KN 20
- 001BA145 KN 20
- 001BA147 KN 21
- 001BA148 KN 21
- 001BA033 KN 22
- 01BA051 LÄ 23
- Cutting Attachment 25
- Mounting the Bar and 25
- Tensioning the Chain 26
- Check Chain Tension 26
- 001BA159 KN 27
- 001BA160 KN 28
- 001BA161 KN 28
- 001BA162 KN001BA163 KN 28
- 165BA003 KN 28
- 001BA158 KN 29
- 143BA024 KN 30
- 143BA011 KN 30
- 143BA012 KN 30
- 171BA022 KN 31
- 171BA002 KN 31
- 171BA003 KN 32
- 143BA018 KN 33
- 143BA019 KN 33
- 143BA020 KN 33
- 133BA001 K 34
- Operating Instructions 35
- 001BA157 KN 36
- Taking Care of the Guide 37
- Air Filter System 37
- 137BA013 KN 38
- Adjusting the Carburetor 40
- Spark Arresting Screen in 41
- Spark Plug 41
- Replacing the Starter Rope 43
- Maintenance and Care 50
- Main Parts 52
- Specifications 54
- Federal Emission Control 56
- Warranty Statement 56
- Trademarks 58
- Contenido 61
- Acerca de este manual de 62
- Medidas de seguridad y 63
- 001BA115 KN 66
- 001BA113 KN 68
- 001BA114 KN 68
- 001BA031 KN 70
- 72
- 001BA040 KN 79
- Accesorio de corte 85
- Montaje de la espada y la 86
- 133BA024 KN 87
- 143BA007 KN 87
- Llenado de combustible 88
- Instrucciones para el uso 96
- Cuidado de la espada 98
- Sistema de filtro de aire 98
- 176BA005 KN 100
- 176BA006 KN 100
- 176BA007 KN 100
- 171BA019 KN 101
- 171BA020 KN 101
- Chispero en el silenciador 102
- 137BA008 KN 103
- 171BA024 KN 103
- 171BA018 KN 103
- Sustitución de la cuerda de 104
- 001BA006 K 105
- 001BA104 ST 106
- 171BA021 KN 106
- 001BA122 KN 107
- 689BA020 KN 108
- 689BA021 KN 108
- 689BA025 KN 108
- 689BA018 KN 109
- 689BA043 KN 109
- 689BA023 KN 109
- 689BA051 KN 110
- 689BA044 KN 110
- Componentes importantes 114
- Especificaciones 116
- Accesorios especiales 117
- Marcas comerciales 121
- ! WARNING! 124
- ! ADVERTENCIA! 124
Produits connexes et manuels pour Scies à chaîne STIHL MS 880 R MAGNUM
(128 pages)© 2020, manymanuals.fr. Tous droits réservés | 2.275 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels